Bubble King® Supermarin 250 + RD3 Speedy

voor aquaria van 1000 liter tot 3000 liter

hard facts Bubble King^® Supermarin 250:

with 10V connection
adjustable Red Dragon^® 3 Mini Speedy pump 50 Watt   1.500 l/h
motor speed adjustable: 300-3000 1/min
Base plate: Ø 27 cm / height ~ 58 cm

Technical data Bubble King 250 Supermarin internal:
Skimmer-pump:
Motor speed adjustable Bubble King Red Dragon^® 3 Mini Speedy pump 50 Watt  1.500 l/h
Delivery rate adjustable: max. ~ 1.500 l/h   Air inlet and max. ~ 4.000 l/h Water inlet
Wattage – active power: P = min. 15Watt  –  max. 50 Watt
operating voltage: 230 Volt 50 Hz  (also in 110V/60Hz available)
Protection class: IP 68

Water level: ~ 180 mm up to ~ 230 mm
Weight skimmer: 11 kg inclusiv pump

Dimension skimmer without pump:
330 mm wide / 290 mm length / ~ 580 mm height
Dimension skimmer with pump (90 ° to torque tube):
360 mm wide / 440 mm length / ~ 580 mm height
Dimension skimmer with pump (compared with torque tube):
500 mm wide / 300 mm length / ~ 580 mm height

Data_sheet_and_spare_parts.pdf     Operating_and_maintenance_manual.pdf
  RD3_Data_sheet_and_spare_parts.pdf  
  RD3_Operating_and_maintenance_manual.pdf

/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
The connection of a controller/computer is prepared in each pump!
Prepared for connection to an aquarium computer (E.g. GHL) via a 0-10V interface.
The additional controller, for the connection to the computer, costs 159€ (incl. all connection cables and main adaptor)

Tested so far folowing these computers:
GHL ProfiLux 3.1 and from Neptune Systems the Apex Aqua Controller.

Compatible with following brands:

https://www.aquariumcomputer.com/
http://www.neptunesystems.com/
https://www.reefai.com/

//////////////////////////////////////////////////////////////////////////////
Functioning of the electronics:
Once a voltage > 0,5V to the 10V interface is, the interface adapter takes over controlling and the system and lock(disable) the buttons on the controller. Voltage will be < 0,5V normal controller operation and the buttons are again released. So can the interface adapter stay connected without performing a function.

If the Aquarium(tank)-computer voltage under 0,5V the 0-10V interface is shut down and the pump can be operated manually. From 0,5V, the interface will take over control of the scheme. In the area of 0,5V-0,8V the pump is switched off. 1V starts the pump at the lowest level (15W) and run. At an increase of 0,5V will increase the level, also. So 1V = 15W  2,5V = 25W ….. 5,0V = 50W.

At a higher input voltage remains the Speedycontroller to the maximum setting are available and no longer increases. The interface adapter behaves as if the corresponding would push the button.
//////////////////////////////////////////////////////////////////////////////////////////////////////////////////